+- MISRA Discussion Forums (https://forum.misra.org.uk)
+-- Forum: MISRA Autocode (https://forum.misra.org.uk/forumdisplay.php?fid=8)
+--- Forum: MISRA AC SLSF discussions (https://forum.misra.org.uk/forumdisplay.php?fid=152)
+--- Thread: namelengthmax (/showthread.php?tid=732)
namelengthmax - ggentile - 29-04-2010
I didn't find any limitation in MISAR AC* in the usage of matlab lenght identifier.
Where I am wrong ?
Giacomo
Re: namelengthmax - Josef.Rieger - 19-08-2010
Hello Giacomo,
the only rule dealing with identifier length I have found is AC TL 2.3 - requirement to enable "code identifiers max. 31 chars" within TargetLink setup.
Regards,
Josef
Re: namelengthmax - ggentile - 30-08-2010
Do you think that is better to add this rule to SLSF also ?
Giacomo
Re: namelengthmax - MISRA Reply - 01-09-2010
The generic modelling guidelines MISRA AC GMG, of which MISRA AC SLSF is a child document as shown in MISRA AC INT, address this point in Rule MISRA AC GMG 006-J. When applying MISRA AC SLSF, users should also apply MISRA AC GMG for generic guidelines applicable to any graphical modelling language.